Powerwalker Battery Pack for VFI 10000R LCD Manual de usuario descargar pdf (Pagina 27)

4. Trouble Shooting

If the UPS system does not operate correctly, please solve the problem by using the table below.

Symptom Possible cause Remedy

No indication and alarm in the front

display panel even though the mains is

normal.

The AC input power is not

connected well.

Check if input cable firmly

connected to the mains.

The icon and the warning code

flash on LCD display and alarm

beeps every second.

EPO function is enabled.

Set the circuit in closed position

to disable EPO function.

The icon and flash on

LCD display and alarm beeps every

second.

The external or internal battery is

incorrectly connected.

Check if all batteries are

connected well.

Fault code is shown as 28, the icon

lights on LCD display, and

alarm beeps continuously.

Battery voltage is too low or the

charger is fault.

Contact your dealer.

The icon and flash on

LCD display and alarm beeps twice every

second.

UPS is overload.

Remove excess loads from UPS

output.

UPS is overloaded. Devices

connected to the UPS are fed

directly by the electrical network

via the Bypass.

Remove excess loads from UPS

output.

After repetitive overloads, the

UPS is locked in the Bypass

mode. Connected devices are fed

directly by the mains.

Remove excess loads from UPS

output first. Then shut down the

UPS and restart it.

Fault code is shown as 43. The

icon

lights on LCD display and

alarm beeps continuously.

UPS is overload too long and

becomes fault. Then UPS shut

down automatically.

Remove excess loads from UPS

output and restart it.

Fault code is shown as 14, the icon

lights on LCD display, and alarm

beeps continuously.

The UPS shut down

automatically because short

circuit occurs on the UPS output.

Check output wiring and if

connected devices are in short

circuit status.

Fault code is shown as 1, 2, 3, 4, 5, 11, 12,

13, 1A, 21, 24, 35, 36, 41 or 42 on LCD

display and alarm beeps continuously.

A UPS internal fault has

occurred. There are two possible

results:

1. The load is still supplied, but

directly from AC power via

bypass.

2. The load is no longer supplied

by power.

Contact your dealer

Battery backup time is shorter than

nominal value

Batteries are not fully charged

Charge the batteries for at least

hours and then check capacity. If

the problem still persists, consult

your dealer.

Batteries defect

ntact your dealer to replace

the battery.

The icon and flash on LCD

display and alarm beeps every second.

Fan is locked or not working; or

the UPS temperature is too high.

Check fans and notify dealer.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 89 90

Comentarios a estos manuales

Sin comentarios

Powerwalker Battery Pack for VFI 10000R LCD Manual de usuario Pagina 27

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Powerwalker Battery Pack for VFI 10000R LCD